Laticrete Hydro Ban 5″ Wide x 16’5″ Long Sealing Tape
Features
Sections of Hydro Ban sheet membrane should be butt-jointed, and the seam between the sheet membrane sections should be covered with sealing tape
Make sure that the sealing tape overlaps each HYDRO BAN Sheet Membrane section by a minimum of 2″ (5 cm)
The floor should be the last section installed. NOTE: Sections of sheet membrane may also be shingled (overlapped) during installation without the need for sealing tape
Treat the vertical corners with the sealing tape next in the same manner as the floor-to-wall transitions were installed. Overlap the corners by 2″ (5 cm)
For any sections where two strips of sealing tape will be joined, be sure to overlap the material by 2″ (5 cm)
It is essential that there should not be excessive overlapping. For example, at the corner, the HYDRO BAN Sealing Tape should overlap the HYDRO BAN Preformed Corner but not the adjacent HYDRO BAN Sealing Tape
