StoneTech Heavy Duty Water-Based Sealer
Use on natural stone such as marble, granite, limestone, slate, and travertine
Features
- Advanced penetrating microbond protection
- Heavy-duty protection against most stains
- It makes cleaning stones easier
- Preserves natural look
- Water-based formula
- Interior and exterior
Directions for Use
- Allow new grout installations to cure for at least 72 hours before application.
- Make sure the surface is clean and free of waxes and coatings
- Sealer may be applied to damp surfaces 1 hour after standing water is removed
- Surface temperature should be between 50°F and 80°F
- Ensure that the area is well-ventilated during application and until the surface is dry
- Mask any surfaces not intended to be treated
- Apply sealer evenly and liberally using a paint pad, roller, or brush
- DO NOT APPLY PRODUCT WITH A SPRAYER
- Allow sealer to penetrate the surface for 15–30 minutes while spreading excess sealer over the entire area for even penetration
- Remove excess sealer by wiping the surface thoroughly with clean, dry towels
- Apply the second coat as needed for porous, absorbent surfaces 30–40 minutes after the first coat, following directions in steps 2 and 3
- 15–30 minutes after final application, wipe the entire surface with clean, dry towels to remove any excess sealer. To remove any residue, reapply a thin coat of sealer, wait 2–3 minutes, then rub lightly with a white nylon pad. Wipe again thoroughly with clean, dry towels
- A complete cure is achieved after 24–72 hours. Foot traffic may begin in 6–8 hours. If needed sooner, cover the floor with red rosin paper to protect it until complete cure is achieved
- Clean tools used during application with water
Available Sizes and Coverage
- Pint 5-50 sq ft
- Quart: 15-100 sq ft
- Gallon: 50-400 sq ft
- 5 Gallon: 250-2,200 sq ft
- Expected Wear: 3-5 years on interior surfaces and 1-3 years on exterior surfaces
