Laticrete Stone Tech Honing Powder 800 Grit Extra Fine
Features
Creates honed finishes
Sets up the stone for polishing and shining
Different grits eliminate mild to deep scratches
Non-acidic
Coverage (600 Grit, 800 Grit): 750-1,500 sq ft per pound
Where to Use
Natural stone such as marble, limestone, travertine and terrazzo
Directions for Use
Read the entire label before using it. Use only as directed
Always test in a small, inconspicuous area to determine ease of application and desired results
Allow new grout installations to cure for a minimum of 72 hours prior to application
Make sure the surface is clean, dry, and free of waxes and coatings
If the surface is heavily soiled, pre-clean with StoneTech Professional KlenzAll Cleaner if needed
Mask any surfaces not intended to be treated. If you are using a variety of abrasive grits, ensure that the surface is well-rinsed and a new pad is used for each changeover
Apply approximately 1/2 cup Honing Powder plus 1 cup clean water to the stone surface
Refinish using a hand orbital sander or weighted floor machine at 130–140 lbs, 175 rpm, fitted with a natural hair pad. Keep the compound wet while refinishing with plenty of water
Add Honing Powder as needed
Refinish the area until the desired level of hone has been achieved
Rinse well and use a wet vacuum or hot water extraction unit to remove all remaining compound
Clean equipment with water
Use successively higher grits of Honing Powder to close the face of the stone and follow with StoneTech Professional Polishing Powder and StoneTech Professional Shining Powder as applicable
